- Joined
- May 3, 2010
- Location
- Houston
I have a 95 ranger 488vs and I want to remove the three bigfoot switches when I put my new foot controlled trolling motor on. Anyone evr do this? I noticed the wires for the switches are connected in the front of the boat and also in the middle around the console where the main pipe of electrical wires run from the batteries on each side. would ranger have spliced into them factory or would the prev. owner have to have got into the tubing himself?
I just want to get rid of the wires and I dont want a bunch of chicken wire or bare wires after I get done and there is not alot of room where the wires come out of the middle of the boat. Confused and Frustrated!!!
Please help anyone if possible!!
Michael<!-- google_ad_section_end --> <!-- / message -->
I just want to get rid of the wires and I dont want a bunch of chicken wire or bare wires after I get done and there is not alot of room where the wires come out of the middle of the boat. Confused and Frustrated!!!
Please help anyone if possible!!
Michael<!-- google_ad_section_end --> <!-- / message -->